Analysis on Application of Solenoid Valve in Cold Storage

Medical Check Valves as a hot industry in industrial production, its products have been widely used in a variety of medical, production, life and other aspects of the device. Of course, the solenoid valve as a production of a good helper, but also by the majority of customers love. Cold storage operation and production, the solenoid valve played a big role. In the cold storage, we often use two forms of solenoid valve, respectively, is a single type of solenoid valve and three-dimensional solenoid valve. In the installation of these solenoid valve, we have to pay special attention to some matters, or will seriously affect the realization of the various functions of the cold storage.
We should pay attention to these aspects of the matter, the first: solenoid valve and the main valve connection, do not force too much, otherwise the middle of the five-hole aluminum sheet pressure, resulting in smaller or blocked through-hole can not turn on The Second: In order to prevent damage to the internal parts of the heat, remove the valve body, and then welding. After welding, the welding slag and the oxide are cleaned to prevent the channel from clogging.
Third: the magnetic isolation sleeve flange and the air cylinder accessories seat to rely on the gasket seal, tighten the screw, the angle should be tightened, if the force will cause uneven leakage. Fourth: both ends of the catheter alignment, vertical connection side of the parallel, with spot welding to ensure that the solenoid valve seal. Fifth: check and remove the electromagnetic valve and the main valve connection parts of the sealing line of the burr or dirt, so as not to scratch the soft aluminum sheet caused by lax.
It can be seen that the manual air control valve in many production and life will often have a great effect, so in the installation and use of the process, I have to pay special attention to the details of the above problems.